Sinoboom 1932ME Error Codes

System Initialization Fault

ECU failed to initialize properly at startup

System Communication Fault

Communication error between platform and ground controls

Invalid Option Setting

Configuration parameters are incorrect or corrupted

Calibration Fault

System requires calibration or calibration data invalid

Key Switch Error

Key switch malfunction or wiring fault

MC Communication Fault

Motor controller communication lost

Battery Draining

Battery charge level low

Motor Controller Fault

General motor controller error detected

Up/Down Switch ON at Power-up

Chassis up or down switch stuck or activated during startup

Pothole Guard Fault

Pothole protection guard sensor fault

Pressure Sensor Fault

Hydraulic pressure sensor error

Angle Sensor Fault

Tilt/angle sensor out of range or disconnected

Pressure Sensor 2 Fault

Secondary pressure sensor error

Battery Drain Alarm

Battery voltage critically low

Left Turn Switch Fault

Left turn switch stuck ON at power-up

Right Turn Switch Fault

Right turn switch stuck ON at power-up

Joystick Enable Switch Fault

Dead-man switch activated at power-up

Joystick Not in Neutral

Drive joystick not centered at power-up

Drive Forward Coil Fault

Forward drive solenoid coil failure

Drive Reverse Coil Fault

Reverse drive solenoid coil failure

Lift Up Coil Fault

Lift up solenoid coil failure

Lift Down Coil Fault

Lift down solenoid coil failure

Right Turn Coil Fault

Right steering solenoid coil failure

Left Turn Coil Fault

Left steering solenoid coil failure

1932ME Low Voltage Fault (battery / ECU under-voltage)

On the Sinoboom 1932ME, under-voltage often appears mid-shift when the taller mast and longer duty cycle pull the pack below cutoff, or when a single weak 6V battery in the series string sags under lift load.

Over 80% Load Warning

Platform load approaching capacity limit

Over 90% Load Warning

Platform load at 90% of rated capacity

Over 99% Load Warning

Platform at maximum rated capacity

Machine Tilted

Machine tilted beyond safe operating angle

Platform Overloaded

Platform load exceeds rated capacity

Platform Up Limit

Platform at maximum height position